Tool · Troubleshooting
Foam, smell, rust and stain.
Possible contributors to common fluid problems and what to check first. Share the readings and a photo for a process discussion.
Foam
Possible contributors
Soft water, concentration too high, too much air at high pump pressure or a low sump level, or cleaner carried in from the wash.
Check first
Water hardness, concentration, sump level and return lines; whether foam started after a change of water or cleaner.
Bad smell
Possible contributors
Microbial activity, tramp oil, low concentration or periods without circulation may contribute.
Check first
Concentration and pH, tramp oil on the surface, and whether the sump circulates during downtime.
Rust on parts or machine
Possible contributors
Low concentration, a falling pH, water quality or parts left wet between operations may contribute.
Check first
Concentration, pH, water quality, drying and storage time, and packing conditions.
Stain on aluminium or copper
Possible contributors
A fluid that is too alkaline for the alloy, long wet contact, or high concentration at the machine.
Check first
The alloy grade, concentration, pH, and how soon the parts are washed and dried.
Skin irritation
Possible contributors
Concentration above the recommended range, dirty or tramp-oil-laden fluid, or long skin contact.
Check first
Concentration and fluid condition. Follow the product's SDS on protective gloves and hygiene, and seek medical advice if irritation continues.
Concentration keeps drifting
Possible contributors
Evaporation, drag-out and top-up practices can change the measured concentration.
Check first
Monitor concentration, confirm the product-specific factor and review the supplier's make-up procedure.
Short die life in cold heading
Possible contributors
Lubrication under load, wire coating, die surface or die geometry may contribute.
Check first
Wire grade and coating, number of blows, and where the pickup appears on the die.
Short sump life
Possible contributors
Tramp oil, fine chips and poor filtration, or a sump that is topped up but never cleaned.
Check first
Filtration, tramp oil removal, and the cleaning routine when the fluid is changed.
