Fastener makers
From the heading die to the export carton.
Bolts, screws, nuts and specials. The fluid questions usually sit at heading, threading, the wash after heat treatment, and the weeks the finished part spends in a container.

A typical fastener line
Review the machining fluid and water-based wash around your existing heat-treatment and finishing steps. For later storage, describe the packaging and corrosion-prevention requirement. Select a blue step to browse the relevant material line or discuss the process requirement.
- 04Heat treatmentHardening and temperingNot supplied
- 06Surface finishPlating, blackening, phosphateNot supplied
- 07Rust protectionStorage and exportNot supplied
Step 01 · Wire drawing
Discuss drawing requirements
Wire breaks, fast die wear or a rough surface after reduction.
Step 02 · Cold heading
Discuss heading requirements
Die galling, short die life or cracked heads can have several causes.
Step 03 · Threading
Discuss threading requirements
Torn threads, tap breakage or poor thread finish.
Step 05 · Washing
Water-based cleaners
Quench-oil residues may interfere with later surface treatment or protection, depending on the process.
What we need in the first email
- The part: bolt, nut, screw, or a special, and the wire grade.
- The step that is in trouble: drawing, heading, thread rolling, tapping, washing, or rust in the carton.
- What you use now, and whether the complaint is die life, surface, smell, or corrosion on arrival.
Related guide: die galling in stainless cold heading.
